Bug on "depend upon" auto-dependency configuration

Post here if you found bugs.
doconeill
starter
starter
Posts: 4
Joined: Wed Apr 24, 2013 21:42

Bug on "depend upon" auto-dependency configuration

Post by doconeill » Mon May 06, 2013 23:17

When I set one checkcommand to be dependent upon another checkcommand, if I go and check the "dependable" command, it will show the dependent service in the "default command to depend upon" pulldown.

For instance, I have a "check_snmp" command, and then a "check_snmp_diskspace" command. If I use the pulldown on check_snmp_diskspace to set it to depend on check_snmp, it works fine...but if I then go to "check_snmp", it will show "check_snmp_diskspace" there as well. Fortunately it does not generate the config in that direction, so it only appears to be a display bug. Even clicking "Submit" in this case does not seem to result in it changing the dependency. However, clicking "Submit" will cause any previous value that should be there (say, check_snmp depends on check_ping) to be lost unless it is explicitly selected again.

If multiple checkcommands are dependent on the same one, it appears to display the last one alphabetically.